Basic Flowy Pants Tutorial for Costumes
In my effort to try and make tutorials for those basic building pieces of cosplay costumes, I decided a pair of elastic waist flowy pants was a good idea. This tutorial is meant to be used with a lightweight material (so the pants will be good for summer conventions).
The pattern was made for a a 3/4 length pant, but you can just lengthen them or shorten them to whatever size your character requires. Print out the pattern that I made for this, or follow the instructions to make your own.
(all of my patterns include 1/2″ seam allowance)
* Note: This pattern will comfortably fit someone to a hip width of about 48 inches. You can make the entire pattern wider by using a starting rectangle that matches your wait measurement, and creating your pattern from there.
or Make Your Pattern:
* The measurements I give you for the I center crotch seam are meant to make it loose so that it will fit most body types. However, if you are very tall or have a bigger bottom, you can lengthen or widen the crotch measurements for a better fit.
This page contains affiliate links. As an Amazon Associate, I earn a small commission from qualifying purchases.
Supplies Needed:
Step 1
hem the top of the pockets
Make a 1/2 inch hem at the top of the pocket.
Step 2
fold over the seam allowance for the pocket
Fold over the seam allowance on the remained three sides of the pocket. Baste in place if necessary.
Step 3
sew the pocket to the pant leg
Center the pocket on the pant legs. Make the top of the pocket 8-12 inches down from the top of the pants. (typically if you are shorter make the pocket higher up. If you are taller make the pocket lower down.)
Note: You can make two pockets if you want to. I like to use one and always put it on the right pant leg so that I can tell at a glance which side is the front and which is the back when wearing the pants without using a clothing tag.
Step 4
sew the pant inseam
Fold the pant legs in half with right sides together and sew the inseam for both legs.
Step 5
sew the pant crotch seam
With right sides together, place one pant leg inside the other. Then line up the crotch seam and sew. Turn the pants to the right side.
Step 6
fold over the top to form a casing
Fold over 1/2 and inch along the top edge. Then fold another 3/4 inch and sew along the bottom to form a casing. You want to leave a small gap in the stitches so you can insert the elastic.
Step 7
insert the elastic into the casing
Cut a piece of 1/2″ elastic that is the size of you waist. Then insert it through the casing. Make sure the elastic isn’t twisted and sew it into a loop. Then sew up the gap in the casing.
Step 8
hem the bottom of the pants
Hem the bottom edge of both pant legs.
Finished!
