Tutorial: Superhero Eye Mask (free sewing pattern)
This page contains affiliate links. As an Amazon Associate, I earn a small commission from qualifying purchases.
Supplies Needed:
(all of my patterns include 1/2″ seam allowance)
Step 1
apply interfacing to the back of the mask
Step 2
Pin the mask to the Mask back
With right sides together, pin the mask front to the mask back pieces. The back is still two separate pieces for now. Draw in the eyeholes from the pattern (note: you may need to slightly adjust the exact location of the eyeholes depending on how wide your eyes are on your face)
Step 3
sew the front and back together around the eyeholes
Step 4
cut out the eye holes
Cut as close as you can to the stitching and clip the curves.
Step 5
Turn the lining through the holes to the back
This is why the back is two separate pieces. Flip both back pieces through the eye holes so that now you have the mask with wrong sides together.
Step 6
Sew the center seam of the back pieces
Step 7
baste the front and back together
Line up the front and back of the mask and baste them together around the edge.
Step 8
fold the strap in half
With right sides together, fold the strap in half and sew down the length and one short side.
Step 9
turn the strap to the right side and press
It can help to use a loop turner to get the strap turned.
Step 10
baste the strap to the sides of the mask
Using an awl (or sharp, pointy tool) poke a hole in the belt about 1.5 inches in from the end (or at the edge of the belting inside so that the hole does NOT go through the belting). Make sure it is centered along the width belt.
Step 11
finish the edges of the mask with single fold bias tape
Start by sewing the bias tape to the mask with right sides together.
Step 12
flip the bias tape to the back and topstitch
Press the bias tape to the back of the mask, covering the raw edges. then topstitch all around the edge to sew it in place.
Finished!
